Dell PowerConnect W-IAP175P User Manual

Automatic Firmware Image Check and Upgrade
Automatic image check is enabled by default. If Dell PowerConnect W-AirWave is configured,
then the automatic image check is automatically disabled, use the manual image check option to
check for the latest image. For more information, see "Upgrading to New Version" on page 88 and
"Configuring Dell PowerConnect W-AirWave" on page 207 for steps on how to configure Dell
PowerConnect W-AirWave.
If the Automatic image check is enabled, then the following actions take place:
l once after every time the AP boots up
l once every week thereafter
If the image check locates a new version of the W-Instant software on the image server, then a
New version available link appears at the top right corner of the Dell W-Series Instant UI.
Figure 63 - Automatic Image Check — New Version Available Link
After the Automatic image check feature identifies a new version, perform the following steps to
upgrade to the new version:
1. The Maintenance window appears. Click Upgrade Now to upgrade the W-IAP to the newer
version.
Figure 64 - New Version Available
After you confirm, the AP downloads the new software image from the server, saves it to flash, and
reboots. Depending on the progress and success of the upgrade, one of the following messages is
displayed:
Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide 87 | Managing W-IAPs

Dell PowerConnect W-IAP175P Specifications

General

Brand	Dell
Model	PowerConnect W-IAP175P
Category	Wireless Access Point
Language	English