Power Controller User access for Power Controller
Digi CM User Guide 125
6 Click Save & apply.
Note The screen above shows that serial port one on the Digi CM unit is connected to a Sun Server
that is supplied power from outlets 1 and 2 on the power controller. In the example above,
Gilligan has access to the power outlets.
7 To select the parameters for the User Access Control, click the User Access link. You may grant
specific users permission to access an outlet or restrict access for specific users from an outlet.
For more information see User access for Power Controller.
User access for Power Controller
The Digi CM unit can be configured to allow all users or specific users access to the power controller
feature as well as restricting specific users to the power controller feature. User Access is configured
on an outlet by outlet basis.
Note User Access to a serial device that is connected to the power controller in configured under
Serial Port > Configuration > Port # > User Access
Configure to allow specific users access
To configure the Digi CM unit for specific users, you must deselect <<Everyone’s>> access and add
the specific user and access as in the following steps.
1 Log in to the Digi CM unit (username root, password dbps)
2 Click Power Controller > Configuration > Outlets > Select the outlet # to configure.
3 Select the port to configure to the outlet. If it is a non-serial device select None.
To Next Page
Loading...
Need help?
General
