Digi CM 8 User Manual

System status and port logging Enable the log storage location
Digi CM User Guide 35
Enable the log storage location
Enable an NFS server
You can save log data to an NFS server, but the NFS server must be configured with read and write
privileges. To use an NFS server, you must specify the NFS server’s IP address and its mounting path.
Encrypted NFS is using a SSH connection to tunnel all data. To enable the NFS server for port or
system logging, do the following:
1 Access the web interface.
2 Under the Network heading, Click NFS server configuration.
NFS service - Enabled or disabled.
Primary NFS server name - IP address of NFS server or
Mounting path on primary NFS server - Directory to primary NFS server
Primary NFS timeout - Interval in seconds before timeout (5-3600)
Primary NFS mount retrying interval - Interval in second between attempts to connect (5-
3600)
Enable/Disable encrypted primary NFS server - If server supports encrypted NFS server
Encrypted primary NFS server user - User name of server
Encryped primary NFS server password - Password
Secondary NFS service - Enabled or Disabled
Secondary NFS server name - Name of server
Mounting path on secondary NFS server - Directory to server
Secondary NFS timeout (sec, 5-3600) - Timeout in seconds
Secondary NFS mount retrying interval (sec, 5-3600) - Retry interval in seconds
Enable/Disable encrypted secondary NFS server - If secondary server supports encrypted NFS
server
Encrypted secondary NFS server user - User name
Encrypted secondary NFS server password - Password
Confirm secondary NFS server password - Repeat password

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English