Digi CM 8 User Manual

Overview .Locater light
Digi CM User Guide 20
Two-step: save to flash and then apply changes
To save multiple changes but apply changes once, do the following:
Choose the Save to flash button.
When you finish changing the configuration, choose the Apply changes link, which is located on the
left navigation menu; or the Save & apply button at the bottom of the page.
For more details about Automatic Device Recognition, refer to
Port 3 shows a real world example of a detected device.
Automatic Device Recognition also monitors each of the configured serial ports. This allows you to
receive an e-mail or SNMP trap if there is a change in the expected response from the device
connected to the serial port. If the device goes down or is disconnected for any reason, you are
notified
.Locater light
The Digi CM 48-port unit has a locater light on the front panel labeled Find Me. All other Digi CM units
flash the serial port lights to indicate where the device is found.
If you access the web interface, log in to the Digi CM unit, and scroll down the page, you will find
additional links.
Click Start device locating and a popup box will appear to confirm. Click okay and the Digi CM unit
Find Me light will blink (other Digi CM models blink all LEDs).
To turn off the locater light, click Stop device locating.

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English