Digi CM 8 User Manual

System status and port logging Enable the log storage location
Digi CM User Guide 37
Enable SYSLOG server
To enable the Digi CM unit for system or port logging on a syslog server:
1 Access the web interface.
2 Under the Network heading, click SYSLOG server configuration.
3 Choose Enable.
4 Enter the IP address of the primary and secondary (if applicable) syslog server, and select the
syslog facility from the drop down menu.
5 Click Save & apply.
Enable a compact-flash card
The compact-flash card must be installed and configured on the Digi CM unit before it can be used
for system logging or storing the Digi CM unit’s configuration information. When storing log files to
an external flash card, the size of the available storage is dependent on both the size of the card and
the port counts of the Digi CM unit used. The maximum settings for log file sizes are listed in the
following table. See also Add a compact-flash card.

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English