Digi CM 8 User Manual

Alerts and notifications SNMP information
Digi CM User Guide 58
3 Fill in the required fields. SMTP with authentication and POP before SMTP require usernames
and passwords.
4 Click Save & apply.
SNMP information
Applications such as NMS (Network Management System) or an SNMP browser can exchange
information with the Digi CM unit and control actions to the unit. The protocol functions defined for
SNMP includes GET, SET, GET-Next, GET-Bulk, and TRAP. Below are the definitions of the protocol
functions found in SNMP. Authentication, power on, and link up traps are supported.
.
Traps
There are additional traps that can be set at the port level. The following table shows where the trap
is under Serial port > Configuration on the web interface, trap name, configure options, and the
trap functions. The MIBs for login traps can be found at http://ftp.digi.com/support/utilities/digicm/
Protocol Function
GET Queries a device for more information
SET Makes changes to a device’s state
GET-Next After an initial GET query, goes to the next value
GET-Bulk Retrieves tables of information and security functions
TRAP Notifies a system administrator of a significant event
Trap Location Trap Name Function
Port access menu Port login trap Notify about any login action to the port access menu
(succeed and fail)
Alert configuration Port login trap Notify about login to this specific port (succeed and fail)
(only available if host mode is set to "Console server")

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English