User Manual Section 8
GFK-2958L May 2021
Commissioning 435
Select modules from the list and drag them to their slot locations in the remote node.
Figure 278
(If you need to delete a module on the left, select it and press the keyboard Delete key).
When the modules on the left are correct, click OK to add them to the configuration.
8.2.3 Configuring EPXPNS001/EPXPNS101 Module
Parameters
After adding RSTi-EP modules to the remote node, their parameters must be configured.
For all EPXPNS001/EPXPNS101 modules, this includes configuring a set of basic parameters
(such as: reference address, length, general parameters).
8.3 Configuring EPXPBS001
The number and types of slave devices that can exchange data with the master are
constrained by memory resources within the master module. The amount of memory
available for the PROFIBUS configuration is affected by the number and types of slave
modules in the network configuration. The total slave configuration data size is limited to
approximately 9KB.
8.3.1 Adding Slaves and Modules
•
To add slaves and modules
1.
Start Emersion PAC Machine Edition.
To Next Page
Loading...
Need help?
General
