Fujitsu M10 User Manual

login:

default
Change

the

panel

mode

switch

to

Locked

and

press

return...

Omitted
Leave

it

in

that

position

for

at

least

5

seconds.
Change

the

panel

mode

switch

to

Service

and

press

return...

Omitted
Note -
Complete this switching operation of the mode switch in 1 minute or less. If the
operation exceeds 1 minute, login authentication times out.
XSCF>
Note -
The following message may be output after login for a building block configuration:
"XSCF firmware update now in progress. BB#xx,please wait for XSCF firmware update
complete." If so, the XCP firmware version is automatically being matched.
Execute the showlogs monitor command to confirm the message of "XCP firmware version
synchronization completed,"
and then perform the next work.
2.
After the login prompt app e ars, enter "default" for the login name.
3.
After a message prompting operation of the mode switch appears, operate
the mode switch on the operation panel as follows.
a. Switch the mode switch on the operation panel to the Locked position, and
press the RETURN key.
b. Leave
the switch in that position for at least 5 seconds.
c. Return the mode switch to the Service position, and press the RETURN key.
4.
Confirm that the system management terminal displays the XSCF shell prompt.
6.4 Checking the XCP Version
This section describes the procedure for checking the XCP version.
In a building block configuration of the M10-4S, all the chassis must have the same
XCP version. Confirm the XCP versions. If any chassis has a different version, update
Chapter 6 Performing an Initial System Diagnosis 183

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English