Fujitsu M10 User Manual

M10-4S units in the system.
Therefore, if there is a physical partition with the same number as that of the BB-ID
of the SPARC M10-4S to be removed, stop that physical partition before removing
the unit.
This physical partition becomes unavailable after removal. So reconfigure the
physical partition with a different
physical partition number.
10.2.1 Removing the server while the target physical
partition (PPAR) is operating
This section describes the removal procedure on the system in "Figure 10-1
Configuration example of 2BB" from a 2BB configuration to a 1BB configuration
while the target physical partition (PPAR) is in operation. To perform maintenance
while the physical partition (PPAR) is operating, use dynamic reconfiguration (DR)
for the physical
partition.
For the software requirements required for this operation, see the latest Fujitsu
M10/SPARC M10 Systems Product Notes and Oracle VM Server for SPARC 3.2
Administration Guide.
For details on the XSCF commands executed in each step, see the Fujitsu M10/SPARC
M10 Systems XSCF Reference Manual.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015278

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English