Fujitsu M10 User Manual

XSCF>

poweron

-y

-a
XSCF>

showpparstatus

-p

0
PPAR-ID

PPAR

Status
00

Running
XSCF>

showboards

-p

0
PSB

PPAR-ID(LSB)

Assignment

Pwr

Conn

Conf

Test

Fault
----

------------

-----------

----

----

----

-------

--------
00-0

00(00)

Assigned

y

y

y

Passed

Normal
01-0

00(01)

Assigned

y

y

y

Passed

Normal

02-0

00(02)

Assigned

y

y

y

Passed

Normal

24.
Execute the show pparstatus command to check the operation status of the
physical partition.
In the following example, the [PPAR Status] field displays "Running," so the
physical partition is operating correctly.
25.
Execute the show boards command to check the system board (PSB) statu s.
In the following example, since both the [Conn] and [Conf]
fields display "y" for
system board 02-0, the system board (PSB) has been added correctly.
26.
Reconfigure the logical domains.
Assign the resources of the installed SPARC M10-4S to an existing logical
domain or a newly configured logical domain. For details, see the Fujitsu
M10/SPARC M10 Systems Domain Configuration Guide.
9.3 Adding Expansion Rack 1 (Installation
for Expansion to Up to the 8BB
Configuration)
This section describes the installation procedure for expansion of direct connections
between chassis in a configuration of up to the 4BB configuration to connections
through crossbar boxes in a configuration of up to the 8BB configuration. This
procedure corresponds to pattern B (1) in Figure 8-1.
9.3.1 Changing a multiple-BB configuration into 1BB
configurations and releasing their connections
Remove the SPARC M10-4S from the existing multiple-BB configuration (direct
connections between chassis), change it to 1BB configurations, and release their
Chapter 9 Installing a System with a Building Block Configuration 265

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English