4. AIS OPERATION
4-11
4.10 AIS Symbol Color
1. Right-click the AIS mode indication then click [Symbol Menu] to show that menu.
2. Select [1 SYMBOL COLOR] and desired color. (Yellow is not available with the
IMO type.)
3. Close the menu.
4.11 AIS Lost Targets
An AIS target is declared a lost target when it fails to produce data
for intervals which are based on the table on page 4-1. When this oc-
curs, the target is marked with the lost target symbol (flashing),
shown in the right figure, the buzzer sounds (for activated targets
only) and the Alert 537 "AIS Lost" appears.
To acknowledge a lost target, push the ALARM ACK key or click the [Alert] box.
Note: The AIS data transmission interval depends on target's speed. For example, the
data is transmitted every 10 seconds on the ship speed of 0 to 14 kn and every two
seconds on the ship speed of more than 23 knots. For details, see the owner's manual
of the AIS transponder.
4.11.1 How to enable, disable the AIS lost target alert
The[ Lost TGT] indication (at the bottom-right position)
enables, disables the lost target alert. Click the indica-
tion to select [OFF], [FILT] or [ALL] as appropriate.
[OFF]: Disable the lost target alert.
[FILT]: Get the alert against the targets whose criteria
meet the settings made in section 4.11.2.
[ALL]: Get the alert against all lost targets.
Note: The [Lost TGT] setting is shared commonly between TT and AIS.
To Next Page
Loading...
Need help?
General
