18. TT AND AIS DISPLAYS
18-4
18.2 AIS Display
18.2.1 AIS symbols
Refer to section 4.3.
18.2.2 Voyage data
Before you embark on a voyage, set your navigation status, ETA, destination, draught
and crew, on the [Voyage Data] page in the [NAV Status] menu. The data entered
here is reflected to the AIS transponder.
Note: [Persons], the total number of persons onboard, should be set at the AIS tran-
sponder. Some AIS transponders may not accept this input from the radar.
1. Open the MENU then click both [NAV Status] in the [TT/AIS] menu and the [Voy-
age Data] tab.
2. Click the [Navigational Status] drop-down list then select your navigational status,
from the list below.
3. Enter ship's draught (0.0 - 25.5 (m)) at [MAX Draught].
4. Enter your ETA at [ETA].
Day: two digits
Month: Three-character abbreviation
Year: Four digits
5. Enter your destination at [Destination], using a maximum of 20 characters.
6. Click the [Save] button to save the settings.
• [Underway using engine]
• [At anchor]
• [Not under command]
• [Restricted maneuverability]
• [Constrained by her draught]
• [Moored]
• [Aground]
• [Engaged in fishing]
• [Under way sailing]
• [Reserved for high speed craft]
• [Reserved for wing in ground]
• [Reserved for future use] (x3)
• [AIS-SART (active)]
• [Not defined]
To Next Page
Loading...
Need help?
General
