Garmin GTN 635 User Manual

5-8
GTN 625/635/650 Pilot’s Guide
190-01004-03 Rev. P
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
5.8 Direct-To a User-Defined Hold
NOTE: This feature is available in software v6.00 and later.
NOTE: Any time a user hold is changed with the Direct-To key, upon pressing
the "Activate the Direct-To Hold" key, navigation guidance will be given back
to the holding fix and the new hold re-initiated.
A user-defined hold can be created as part of a Direct-To to any waypoint.
Automatic waypoint sequencing will be suspended during the hold.
1. Press the Direct-To key to display the Direct-To page.
Touch to Select
Specific Course
Direct-To Wpt
Touch to Create Hold
at Direct-To Wpt
Figure 5-11 Create Hold at Direct-To Waypoint
2. Touch the Hold key. The Direct-To Hold page is displayed.
Touch to Select
Specific Course
Touch to Select
Turn Direction
Touch to Accept
Hold Parameters
Touch to Select Direction
Touch to Select
Leg Length Type
Touch to Select Leg Length
Touch to Select
EFC Time
Touch to Preview
Selected Hold
Figure 5-12 Entering Direct-To Hold Parameters
3. Touch the Course key to open the keypad. Use the keypad
and the Enter key to select the inbound or outbound course.
4. Touch the Direction key to select between Inbound or
Outbound for the course direction.
5. Touch the Turn key to select between Left or Right for the turn
direction.
6. Touch the Leg Type key to select between Time or Distance
for the leg type.
7. Touch the Leg Time or Leg Distance key to display the keypad.
Use the keypad and the Enter key to select the length of the leg.

Garmin GTN 635 Specifications

General

Brand	Garmin
Model	GTN 635
Category	GPS
Language	English