Garmin GTN 635 User Manual

6-9190-01004-03 Rev. P
GTN 625/635/650 Pilot’s Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
6.4 Selecting an Approach
Only one approach can be loaded at a time in a flight plan. If an approach
is loaded when another approach is already in the active flight plan, the new
approach replaces the previous approach. The route is defined by selection of an
approach, the transition waypoint, and a runway.
NOTE: In software v6.21 and later, the pilot may load an alternate
approach during a missed approach procedure. The GTN retains all
missed approaches in the flight plan.
1. Touch the PROC key on the Home page. The Approach, Arrival,
and Departure fields will be dashed until a selection is made.
Touch to Select
Departure
Touch to Select
Arrival
Touch to Select
Approach
Figure 6-15 Procedures Selection Window
2. Touch the Approach key on the Procedures page to select
an approach for the destination airport. Confirm that the
intended airport is shown or touch the Airport key and select
the desired airport.
NOTE: If using Descent VNAV, verify that the altitudes for the selected
procedure match the charted or ATC cleared altitudes and are appropriate
for the airframe type.
Touch to Select
Approach
Touch to Select
Airport
Touch to Select
Channel ID
Figure 6-16 Selecting an Approach

Garmin GTN 635 Specifications

General

Brand	Garmin
Model	GTN 635
Category	GPS
Language	English