14-8
GTN 625/635/650 Pilot’s Guide
190-01004-03 Rev. P
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
14.1.5 Before/After Target Waypoint
This setting designates whether the offset distance defines a point before you
reach the target reference waypoint or after you reach the waypoint. The “After”
selection is not available for the last waypoint in a flight plan.
1. While viewing the VCALC page, touch the Before/After key.
2. Touching the Before/After key will toggle between before
and after the Target Waypoint.
14.1.6 Target Waypoint
Select the waypoint in the flight plan that will be used for planning a descent.
When using a flight plan, the target waypoint is a reference that can be specified
from the waypoints contained in the flight plan. By default, the last waypoint in
the flight plan is selected.
1. While viewing the VCALC page, touch Target Waypoint.
Figure 14-9 Select VCALC Target Waypoint List
2. A list of the remaining waypoints in the flight plan will be
shown. Touch the desired waypoint to select it as the Target
Waypoint.
To Next Page
Loading...
Need help?
General