2-11190-01004-03 Rev. P
GTN 625/635/650 Pilot’s Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
2.3 Telligence
TM
Voice Command
Garmin's Telligence Voice Command voice recognition feature allows the
pilot (and optionally copilot) to control the GTN 6XX connected to a GMA
350 using spoken commands. To activate Voice Recognition, push and hold
the Push-to-Command (PTC) switch while speaking a command. When the
Push-to-Command switch is released, the GTN 6XX and/or the audio panel will
respond.
If a command is understood by the GMA, a positive acknowledgement chime
will be played, and the relevant information will be displayed to reflect the change
(if applicable). The pilot should verify that the correct response has occurred
.
If a command is not understood by the GMA or the GTN is unable to complete
the requested action, a negative acknowledge tone will be played. The pilot should
repeat the command by using the Push-to-Command switch, or by manually
using the GTN 6XX touch screen. In the event of any abnormal Voice Recognition
operation, the front panel controls and touch screen may be used to override Voice
Recognition and manually control the GTN 6XX.
NOTE: If Telligence Voice Command malfunctions and needs to be disabled,
remove power to the GMA 350 audio panel. This will force the audio panel
into the fail-safe mode. The pilot will be able to communicate using the
COM 2 radio only.
The available voice recognition commands are listed in the GTN 6XX/7XX
Telligence Voice Command Guide, P/N 190-01007-50.
To Next Page
Loading...
Need help?
General