143
Saving Data
When the auto-save with the wave data (binary) setting is enabled, the data can be recovered upon
recovery of communications with the wireless modules from communications disruption. However,
when the segment save is enabled, the system cannot recover data in les that have already been
saved after segmented.
The system can recover data acquired until only when the les to be currently being saved was
segmented.
When the auto-save with the text format is enabled, the system cannot recover data. The
instrument will save the data that were not able to be received due to communications disruption in
other les after communications are reestablished. The unreceived data will be saved in a le under
the new name with the characters [_R] added to the end of the original lename.
Example: When the name of the original le is AUTO0001.CSV
The instrument will save the unreceived data in the AUTO0001_R.CSV le.
The instrument with no storage media inserted cannot recover data. (p. 409)
Data protection (When Z1007 Battery Pack is used)
The instrument will stop saving data when the battery starts to run out during auto-save operation
(Measurement will continue).
Media crash, which can occur because of system shutdown during saving operation, can be
prevented.
IMPORTANT
Hioki guarantees the operation of our optional SD Memory Card and USB Drive only. Operation
of any other storage media cannot be guaranteed.
Saving and Loading Data
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Need help?
General
