222
Controlling the System
Performing a self-check
This section describes how to perform a self-check.
The results will be shown on the screen. Contact your authorized Hioki distributor or reseller in the
event of an abnormal result.
> >
1
1
Select the type of diagnostics you wish to perform in the [Self check] area and press the
ENTER key.
The self-check window will open.
2
Follow the instructions to perform the self-check.
Key... Checks key recognition. Additionally, veriîš¿es that the LEDs are working properly.
The self-check will end once all keys have been checked.
You can force-quit the self-check in the event of a malfunction by pressing the ESC key
twice.
LCD... Checks the screen display.
The screen will cycle through the following colors and then return to the original screen
each time you press a key:
White → black → red → green → blue → gradation
ROM/RAM... Checks the instrument’s built-in memory (ROM, RAM).
LAN... Checks if the LAN interface operates properly.
If a FAIL judgment exhibits, check cable connection and settings including the IP
address and îš¿rewall.
If such a condition cannot be corrected, please contact your authorized Hioki distributor
or reseller to have the instrument repaired.
Media... Checks if the SD Memory Card and USB Drive can be detected.
Unit... Displays information about connected modules and checks their status.
When you press the ENTER key while [Reference] of the wireless module you wish
to conîš¿rm is selected, the LED of the wireless module concerned will blink for a few
seconds.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
