7.3 Test procedure using the wireless remote control
N O T E
The test run cannot be carried out using the wireless remote control if the remote control is being used or if several
units (SET-FREE, DC INVERTER and UTOPIA series) are running at the same time. In this case, carry out the test
using the remote control.
Carry out the test run once the installation work is complete.
1 Fit the batteries in the remote control.
2 Switch on the power supply to the indoor and outdoor units.
3 The yellow LED on the indoor unit receiver flickers. While the
LED is flickering, the indoor unit will not operate because it is
starting up.
Select the TEST RUN mode
1 Press the SET and OFF TIME buttons at the same time for
more than 3 seconds. The indication on the LCD screen of the
remote control must be as follows. TEST RUN mode is not
operational.
7 Test run
228
SMGB0063 rev. 1 - 10/2010
To Next Page
Loading...
Need help?
General
