218 8680i User Guide
Replace the Finger Strap
Replace the finger strap when it becomes old or worn.
1. Open the length of the old finger strap so it is only attached to one side of the
device. Slide the silver spring bar to detach the finger strap from the device.
2. Slide and hold the silver spring bar on the new finger strap and slide it into
place.
3. Release the spring bar.
Troubleshooting
Note: Make sure your battery is charged.
Is the scanner having trouble reading your symbols?
If the scanner isn’t reading symbols well, check that the symbols:
• Aren’t smeared, rough, scratched, or exhibiting voids.
• Aren’t coated with frost or water droplets on the surface.
• Are enabled in the host to which the scanner connects.
Is the bar code displayed but not entered into the application?
The bar code is displayed on the host device correctly, but you still have to press a
key to enter it (the Enter/Return key or the Tab key, for example).
• You need to program a suffix. Programming a suffix enables the scanner to
output the bar code data plus the key you need (such as “CR”) to enter the data
To Next Page
Loading...
Need help?
General
Weight and Dimensions
