Honeywell 8680i User Manual

22 8680i User Guide
Reset Custom Defaults
If you want the custom default settings restored to your 8680i, scan the Activate
Custom Defaults bar code below. This is the recommended default bar code for
most users. It resets the 8680i to the custom default settings. If there are no cus-
tom defaults, it resets the 8680i to the factory default settings. Any settings that
have not been specified through the custom defaults are defaulted to the factory
default settings.
Note: The 8680i resets and becomes unlinked from the host after using the Defaults
commands. See Auto Reconnect Mode on page 24 to relink the 8680i.
Activate Custom Defaults

Honeywell 8680i Specifications

General

Type	Wearable bar code reader
Sensor type	-
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Motion tolerance (cm/s)	584
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	Code 39, PDF417, U.P.C.
2D (matrix & stacked) barcodes supported	Data Matrix, PDF417
Bluetooth version	4.1
Standard interfaces	Bluetooth
Connectivity technology	Wireless
Product color	Black
Built-in display	No
International Protection (IP) code	IP54
Charging time	4 h
Battery voltage	3.6 V
Power source type	Battery
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	81 mm
Width	56 mm
Weight	- g