Honeywell 8680i User Manual

8680i User Guide 49
ness is decreased, making it less aggressive when reading good quality bar codes.
This setting does not affect 1D bar code reading. Default = Poor Quality PDF Read-
ing Off.
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the Lights On
bar code, below. However, if you want to turn just the lights off, scan the Lights Off
bar code. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using Aimer
Mode (page 50).
Aimer Delay
The aimer delay allows a delay time for the operator to aim the 8680i before the
image is taken. Use these codes to set the time between when the trigger is pressed
and when the image is taken. During the delay time, the aiming light appears, but
the LEDs won’t turn on until the delay time is over. Default = Off.
Poor Quality PDF Reading On
* Poor Quality PDF Reading
Off
* Lights On
Lights Off
200 milliseconds
400 milliseconds

Honeywell 8680i Specifications

General

Type	Wearable bar code reader
Sensor type	-
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Motion tolerance (cm/s)	584
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	Code 39, PDF417, U.P.C.
2D (matrix & stacked) barcodes supported	Data Matrix, PDF417
Bluetooth version	4.1
Standard interfaces	Bluetooth
Connectivity technology	Wireless
Product color	Black
Built-in display	No
International Protection (IP) code	IP54
Charging time	4 h
Battery voltage	3.6 V
Power source type	Battery
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	81 mm
Width	56 mm
Weight	- g