8680i User Guide 73
DATA FORMAT
Data Format Editor Introduction
You may use the Data Format Editor to change the 8680i’s output. For example,
you can use the Data Format Editor to insert characters at certain points in bar
code data as it is scanned. The selections in the following pages are used only if
you wish to alter the output. Default Data Format setting = None.
Normally, when you scan a bar code, it is output automatically. However, when you
create a format, you must use a “send” command (see Send Commands on page
76) within the format program to output data.
Multiple formats may be programmed into the 8680i. They are stacked in the order
in which they are entered. However, the following list presents the order in which
formats are applied:
1. Specific Terminal ID, Actual Code ID, Actual Length
2. Specific Terminal ID, Actual Code ID, Universal Length
3. Specific Terminal ID, Universal Code ID, Actual Length
4. Specific Terminal ID, Universal Code ID, Universal Length
5. Universal Terminal ID, Actual Code ID, Actual Length
6. Universal Terminal ID, Actual Code ID, Universal Length
7. Universal Terminal ID, Universal Code ID, Actual Length
8. Universal Terminal ID, Universal Code ID, Universal Length
The maximum size of a data format configuration is 2000 bytes, which includes
header information.
If a bar code is read that fails the first data format, the next data format, if there is
one, will be used on the bar code data. If there is no other data format, the raw data
is output.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
