Honeywell 8680i User Manual

8680i User Guide 17
1. Scan the Bluetooth HID Keyboard Disconnect bar code below.
2. Use the 8680i to scan the EZPairing bar code that is either supplied with the
device, attached to the device, or displayed on the screen. The EZPairing bar
code begins with {FNC3} LnkB, followed by 12 digits, like the sample below.
The Bluetooth symbol appears in the user window when the 8680i pairs with a
host. Once the 8680i battery is charged and you have paired it to a host device, you
may begin scanning bar codes. Verify the 8680i operation by scanning a bar code
from the Sample Symbols, beginning on page 233.
Pair with a Honeywell Communication and Charge Base
or Access Point
The 8680i can communicate with the following Honeywell Communication and
Charge base (CCB) and Honeywell Bluetooth Access Points:
Granit CCBs:
• CCB02-100BT-07N
• CCB05-100BT-07N
Xenon CCBs:
• CCB01-010BT-07N
Access Points:
•AP-100BT-07N
• AP05-100BT-07N
•AP-010BT-07N
Bluetooth HID Keyboard Disconnect

Honeywell 8680i Specifications

General

Type	Wearable bar code reader
Sensor type	-
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Motion tolerance (cm/s)	584
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	Code 39, PDF417, U.P.C.
2D (matrix & stacked) barcodes supported	Data Matrix, PDF417
Bluetooth version	4.1
Standard interfaces	Bluetooth
Connectivity technology	Wireless
Product color	Black
Built-in display	No
International Protection (IP) code	IP54
Charging time	4 h
Battery voltage	3.6 V
Power source type	Battery
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	81 mm
Width	56 mm
Weight	- g