8680i User Guide 71
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay bar code below, then scan the number of 5ms delays, and
the Save bar code from the Programming Chart, beginning on page 235.
To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0. Scan the Save bar code from the Programming Chart, beginning on
page 235.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays, and the Save
bar code from the Programming Chart, beginning on page 235.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a
printable character to trigger the delay (see Lower ASCII Reference Table,page
225.
)
To remove this delay, scan the Delay Length bar code, and set the number of
delays to 0. Scan the Save bar code from the Programming Chart, beginning on
page 235.
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay
Character to Trigger Delay
To Next Page
Loading...
Need help?
General
Weight and Dimensions
