Honeywell Notifier ID50 User Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
Configuration Mode
95 997-263-000-11, Issue 11
January 2010
5.10.2 Wipe Memory
CAUTION: USE THIS OPTION WITH CARE! ALL
CONFIGURATION PARAMETERS WILL BE DELETED!
To wipe the panel’s memory, display the System menu
and proceed as follows:
1 Using the numeric keypad, press the ‘
2
’ button to
select the Wipe Memory option.
2 Press the ‘
5
’ button to confirm the wipe memory
procedure. The LCD displays the following message.
When the configuration has been wiped the LCD re-
displays the System menu.
5.11 Normal
The Normal function returns the display to the Level 2
Configuration menu in a normal supervisory mode.
To return to the Level 2 Configuration menu and retain
Level 3 access (Engineer):
1 Press the ‘
2
/
8
’ buttons to display additional
options (6 : System, 7 : Normal and ¦ : More) from
the Commissioning menu.
2 Using the numeric keypad, press ‘
7
’. The panel will
reset and return to normal supervisory mode at the
User Menu.
When ALL configuration procedures have been
completed, remember to fit the Configuration
Lock jumper Link (J9).
[S1 COMM] 1 : Setup 2 : Circuit
3 : CBE Rules 4 : Zones 5 : Access ¦ : More
[S1 COMM] 6 : System 7 : Normal
¦ : More
[S1] 1:Test 2:Disable/Enable 3:Clock
4:View Mode 5:Commission
or
82
7
[S1 SYSTEM] 1 : Crystal 2 : Wipe Memory
Wipe ALL configuration memory
Press to confirm < : Cancel
Wiping configuration memory
Please wait . . .
5
2

Honeywell Notifier ID50 Specifications

General

Brand	Honeywell
Model	Notifier ID50
Category	Control Panel
Language	English