Honeywell Touchpoint Plus Technical Handbook

MAN0984_Iss 4_01/19 Touchpoint Plus
Pt. No. 3011M5001 24 Technical Handbook
3.2 Equipment Specification
3.2.1 Power Requirements (Controller Unit only)
The Touchpoint Plus system is designed to operate on a single phase, 50 to 60 Hz, 110/220 V~ (AC) supply with a
typical power consumption of less than 107 W.
Alternatively it can be connected to an 18 32 V (DC) supply with typical power consumption less than 107 W.
The system can contain an optional backup battery to guard against short-term power disruption.
Nr.
Power Usage
Module
Qty
Power
Total Power (Max) W
Remarks
mA
in
mV in
Dual
in
1
UI Module
1
3.4
3.4
3.4
3.4
2
Main Module
1
1.0
1.0
1.0
1.0
3
mA Input Module
1
0.3
0.3
8 ch, not including Field Device
power
mA input Field
Devices
-
40
40
20
Field Device power ( 8 ch* 5W)
Field Device power ( 4 ch* 5W)
mV Input Module
1
18.5
18.5
8 ch
Dual Input Module
1
9.4
9.4
4 ch mA and 4 ch mV
4
mA Output Module
2
4.2
8.4
8.4
8.4
5
Relay Output
Module
2
2.5
5.0
5.0
5.0
6
Charging power for
backup battery
pack
1
6
6
6
6
7
Audio/Visual Alarm
-
28.8
28.8
28.8
28.8
When alarm devices are
connected
8
SMPS Power Loss
-
14.0
14.0
14.0
14.0
MAXIMUM CONSUMPTION
107
85
96
Table 1. Maximum Power Consumption Calculations
Input
Voltage Range AC
AC 110/220 V manually switchable
300 VAC surge for 5 sec without damage
AC Frequency Range
50 60 Hz ± 6%
Output
DC Voltage
24 V
Rated Current
6.5 A
Current Range
0 6.5 A
Rated Power
156 W
Protection
Overload
110 150 % rated output power
Over-Volt
27.6 32.4 VDC Hiccup mode, which recovers automatically when
the fault is removed.
Table 2. Power Supply (SMPS RS–150–24) Electrical Ratings

Honeywell Touchpoint Plus Specifications

General

Brand	Honeywell
Model	Touchpoint Plus
Category	Controller
Language	English