Commissioning
MAN0984_Iss 4_01/19 Touchpoint Plus
Pt. No. 3011M5001 56 Technical Handbook
6.4
Date, Time and
Language Settings
System Date and Time settings are used by the events log, so you should decide whether to use Local or UTC time.
Using UTC means that you have a global time stamp and you do not have to adjust for daylight saving time.
Note: You should replace the CMOS battery every two years or when the time and date settings are not retained after
power is cycled. Refer to Ch.5.3 Modbus Remote Terminal Unit (RTU) and Transmission Control Protocol (TCP)
Connections for more information.
Note: You should regularly check the time and date settings and adjust them if required. Touchpoint Plus does not
adjust automatically for daylight savings time so it retains a copy of the earlier data if the clock is backdated (e.g.
when ending daylight savings time), which can show as a mismatch in the events log chronology.
6.4.1 How to Set or Change Date, Time and Language Settings
1) Touch the Login icon in the navigation bar and a login prompt will ask for the access level and Password.
2) Login to the Service access level.
3) From the navigation bar select Menu>Configuration>General>Date / Time.
4) Set the date, time and display format as required.
5) Touch [Finish].
6.5 Service Contact Settings
To set the Service contact:
1) Login as Administrator or Service.
2) Touch Menu>Configuration>General>Service Contact.
3) Update the settings with your local service support contact details.
4) Touch [Finish] and return to the Configuration menu.
To Next Page
Loading...
Need help?
General
