HP 5920 Configuration Guide

104
Ste
p
Command Remarks
7. (Optional.) Configure
the interval for sending
periodical traps.
snmp-agent trap periodical-interval
interval-time
By default, the SNMP agent sends
a periodical trap every 60
seconds.
This configuration is available in
Release 2311P04 and later
versions.
Displaying the SNMP settings
Execute display commands in any view. The display snmp-agent community command is supported only
in non-FIPS mode.
Task Command
Display SNMP agent system information, including
the contact, physical location, and SNMP version.
display snmp-agent sys-info [ contact | location |
version ]
Display SNMP agent statistics. display snmp-agent statistics
Display the local engine ID. display snmp-agent local-engineid
Display SNMP group information. display snmp-agent group [ group-name ]
Display remote engine IDs.
display snmp-agent remote [ ip-address
[ vpn-instance vpn-instance-name ] | ipv6
ipv6-address [ vpn-instance vpn-instance-name ] ]
Display basic information about the notification
queue.
display snmp-agent trap queue
Display the modules that can generate notifications
and their notification status (enable or disable).
display snmp-agent trap-list
Display SNMPv3 user information.
display snmp-agent usm-user [ engineid engineid |
username user-name | group group-name ] *
Display SNMPv1 or SNMPv2c community
information. (This command is not supported in FIPS
mode.)
display snmp-agent community [ read | write ]
Display MIB view information.
display snmp-agent mib-view [ exclude | include |
viewname view-name ]
Display SNMP MIB node information.
display snmp-agent mib-node [ details | index-node
| trap-node | verbose ]
Display an SNMP context. display snmp-agent context [ context-name ]
SNMPv1/SNMPv2c configuration example
SNMPv1 configuration procedure is the same as the SNMPv2c configuration procedure. This example
uses SNMPv1, and is available only for non-FIPS mode.

HP 5920 Specifications

General

Brand	HP
Model	5920
Category	Switch
Language	English