HP 5920 Configuration Guide

134
Ste
p
Command Remarks
7. Specify the source IP address of
ICMP echo request.
source ip ip-address
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface and the
interface must be up.
8. Specify the number of ICMP
echo requests to be sent in a
path jitter operation.
probe packet-number
packet-number
The default setting is 10.
9. Specify the interval for sending
ICMP echo requests.
probe packet-interval
packet-interval
The default setting is 20 milliseconds.
10. Specify how long the NQA
client waits for a response from
the server before it regards the
response times out.
probe packet-timeout
packet-timeout
The default setting is 3000
milliseconds.
11. (Optional.) Specify an LSR path.
lsr-path ip-address&<1-8>
By default, no LSR path is specified.
The path jitter operation uses the
tracert to detect the LSR path to the
destination, and sends ICMP echo
requests to each hop on the LSR.
12. (Optional.) Perform the path
jitter operation on destination
only.
target-only
By default, the path jitter operation is
performed on each hop on the path
to the destination.
Configuring optional parameters for the NQA operation
Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
To configure optional parameters for an NQA operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA
operation and enter NQA
operation view.
nqa entry admin-name
operation-tag
By default, no NQA operation is created.
3. Specify an NQA
operation type and enter
its view.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | path-jitter |
snmp | tcp | udp-echo |
udp-jitter | voice }
N/A
4. (Optional.) Configure a
description.
description text By default, no description is configured.

HP 5920 Specifications

General

Brand	HP
Model	5920
Category	Switch
Language	English