HP 5920 Configuration Guide

132
Ste
p
Command Remarks
5. Specify the destination port of
voice packets.
destination port port-number
By default, no destination port
number is configured.
The destination port must be the same
as that of the listening service on the
NQA server.
6. Specify the codec type.
codec-type { g711a | g711u |
g729a }
By default, the codec type is G.711
A-law.
7. Specify the advantage factor
for calculating MOS and
ICPIF values.
advantage-factor factor By default, the advantage factor is 0.
8. (Optional.) Specify the source
IP address of voice packets.
source ip ip-address
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
voice packets can be sent out.
9. (Optional.) Specify the source
port number of voice packets.
source port port-number
By default, no source port number is
specified.
10. (Optional.) Specify the
payload size in each voice
packet.
data-size size
By default, the voice packet size
depends on the codec type. The
default packet size is 172 bytes for
G.711A-law and G.711 μ-law codec
type, and 32 bytes for G.729 A-law
codec type.
11. (Optional.) Specify the string
to be filled in the payload of
each voice packet.
data-fill string
The default setting is the hexadecimal
number
00010203040506070809.
12. Specify the number of voice
packets to be sent in a voice
probe.
probe packet-number
packet-number
The default setting is 1000.
13. Specify the interval for
sending voice packets.
probe packet-interval
packet-interval
The default setting is 20 milliseconds.
14. Specify how long the NQA
client waits for a response
from the server before it
regards the response times
out.
probe packet-timeout
packet-timeout
The default setting is 5000
milliseconds.
NOTE:
Use the display nqa result command or the display nqa statistics command to verify the most recent resul
t
of the voice operation. The display nqa history command does not display the voice operation results or
statistics.
Configuring the DLSw operation
The DLSw operation measures the response time of a DLSw device.

HP 5920 Specifications

General

Brand	HP
Model	5920
Category	Switch
Language	English