242
</env:Header>
<env:Body>
<rpc message-id ="100" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<get-bulk>
<filter type="subtree">
<top xmlns="http://www.hp.com/netconf/data:1.0">
<IF>
<Interfaces>
<Interface/>
</Interfaces>
</IF>
</top>
</filter>
</get-bulk>
</rpc>
</env:Body>
</env:Envelope>
How to use NETCONF
You can use NETCONF to manage and configure the device by using the methods in Table 28.
Table 28 NETCONF methods for configuring the device
Confi
uration tool Lo
in method
Remarks
CLI
• Console port
• SSH
• Telnet
To implement NETCONF operations, copy valid
NETCONF messages to the CLI in XML view.
This method is suitable for R&D and test
purposes.
Custom interface N/A
To use this method, you must enable NETCONF
over SOAP.
By default, the device cannot interpret Custom
interfaces' URLs. For the device to interpret these
URLs, you must encode the NETCONF messages
sent from a custom interface in SOAP.
Protocols and standards
• RFC 3339, Date and Time on the Internet: Timestamps
• RFC 4741, NETCONF Configuration Protocol
• RFC 4742, Using the NETCONF Configuration Protocol over Secure SHell (SSH)
• RFC 5277, NETCONF Event Notifications
• RFC 5539, NETCONF over Transport Layer Security (TLS)
• RFC 6241, Network Configuration Protocol
To Next Page
Loading...
Need help?
General
