HP 5920 Configuration Guide

78
Severity
v
alue
Level Description
1 Alert
Action must be taken immediately. For example, traffic on an interface exceeds
the upper limit.
2 Critical
Critical condition. For example, the device temperature exceeds the upper limit,
the power module fails, or the fan tray fails.
3 Error Error condition. For example, the link state changes.
4 Warning
Warning condition. For example, an interface is disconnected, or the memory
resources are used up.
5 Notification
Normal but significant condition. For example, a terminal logs in to the device,
or the device reboots.
6 Informational
Informational message. For example, a command or a ping operation is
executed.
7 Debugging Debug message.
Log destinations
The system outputs logs to the following destinations: console, monitor terminal, log buffer, log host, and
log file. Log output destinations are independent and you can configure them after enabling the
information center.
Default output rules for logs
A log output rule specifies the source modules and severity level of logs that can be output to a
destination. Logs matching the output rule are output to the destination. Table 7 shows the default log
output r
ules.
Table 7 Default output rules
Destination Lo
g
source modules Out
p
ut switch Severit
y
Console All supported modules Enabled Debug
Monitor terminal All supported modules Disabled Debug
Log host All supported modules Enabled Informational
Log buffer All supported modules Enabled Informational
Log file All supported modules Enabled Informational
Default output rules for diagnostic logs
Diagnostic logs can only be output to the diagnostic log file, and cannot be filtered by source modules
and severity levels. Table 8 shows the default output rule for diagnostic logs.

HP 5920 Specifications

General

Brand	HP
Model	5920
Category	Switch
Language	English