Problem Cause Solution
The power switch on the
device is not turned on.
Power off the workstation, and power on the external
device, then turn on the workstation to integrate the device
with the workstation system.
The IEEE-1394 port is not active. The port is not there because it
was not purchased with the
system.
You can buy an IEEE 1394 PCI adapter card. Contact an
HP seller.
Solving hardware installation problems
You might need to reconfigure the workstation when you add or remove hardware, such as an additional
diskette drive. If you install a PNP (positive-negative-positive) device, Windows XP automatically
recognize the device and configure the workstation. If you install a non-PNP device, you must
reconfigure the workstation after completing installation of the new hardware.
Table 5-12 Hardware installation problems
Problem Cause Solution
A new device is not recognized as
part of the system.
Device is not seated or
connected properly.
Be sure that the device is properly and securely connected
and that pins in the connector are not bent.
Cables of new external device
are loose or power cables are
unplugged.
Be sure that all cables are properly and securely connected
and that pins in the cable or connector are not bent.
Power switch of new external
device is not turned on.
Power off the workstation, power on the external device,
and power on the workstation to integrate the device
with the workstation system.
When the system advised you
of changes to the
configuration, you did not
accept them.
Reboot the workstation, and follow the instructions for
accepting the changes.
A PNP board might not
automatically configure when
added if the default
configuration conflicts with
other devices.
Use the Device Manager to clear the automatic settings for
the board and select a basic configuration that does not
cause a resource conflict. You can also use Computer
Setup to reconfigure or disable devices to resolve the
resource conflict.
Device hardware is not
properly jumpered or
otherwise configured.
Read the device-specific configuration information and
check for incorrect settings or conflicts with other devices
already installed in the system.
Workstation will not start. Wrong memory modules were
used in the upgrade or memory
modules were installed in the
wrong location.
1. Review the documentation that came with the system
to determine if you are using the correct memory
modules and to verify the proper installation.
2. Observe the beeps and LED lights on the front of the
workstation. Refer to
POST error messages
on page 123 to determine possible causes.
PCI Express power cable
might be plugged into the
wrong connector on the
system board.
Connect the auxiliary PCI Express power cable to the PCI
Express card.
Table 5-11 Front panel component problems (continued)
ENWW Troubleshooting scenarios and solutions 117
To Next Page
Loading...
Need help?
General