EasyManuals Logo
Home>HP>Desktop>XW8400

HP XW8400 User Manual

HP XW8400
210 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
To recover the system after it enters Boot Block recovery mode:
1. If there is a diskette in the diskette drive or a CD in the CD drive, remove the diskette and CD, and
power down the system.
2. Insert a ROMPaq diskette into the diskette drive, or if permitted on this workstation, insert a
ROMPaq CD into the CD drive. USB media such as an HP DriveKey can also be used.
3. Power on the workstation.
If no ROMPaq diskette or ROMPaq CD is found, you will be prompted to insert one and restart the
workstation.
If a setup password has been established, the Caps Lock light illuminates and you are prompted
to enter the password.
4. Enter the setup password.
If the system successfully starts from the diskette and successfully reprograms the ROM, then the
three keyboard lights illuminate. A rising tone series of beeps also signals successful completion.
5. Remove the diskette or CD, and restart the system.
The following table lists the various keyboard light combinations used by the Boot Block ROM (when a
PS/2 keyboard is attached to the workstation) and explains the meaning and action associated with
each combination.
Table 3-2 Keyboard light combinations used by Boot Block ROM
Light State Description
FailSafe Boot
Block Mode
Keyboard LED Activity State/Message
Num Lock On ROMPaq diskette or ROMPaq CD not present, is bad, or drive not ready
Caps Lock On Enter password
Num, Caps,
Scroll Lock
Blink On in sequence,
one at a time—N,C, SL
Keyboard locked in network mode
Num, Caps,
Scroll Lock
On Boot Block ROM Flash successful.
Diagnostic lights do not flash on USB keyboards.
Replicating the setup
The following procedures enable you to easily copy one setup configuration to other workstations of the
same model to provide faster, more consistent configuration of multiple workstations.
NOTE Both procedures require a diskette drive or a USB device such as an HP DriveKey.
To collect and replicate BIOS settings on multiple computers, use System Software Manager or
HP Client Manager Software. For more information, see
http://www.hp.com/go/easydeploy.
36 Chapter 3 System management ENWW

Table of Contents

Other manuals for HP XW8400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP XW8400 and is the answer not in the manual?

HP XW8400 Specifications

General IconGeneral
BrandHP
ModelXW8400
CategoryDesktop
LanguageEnglish

Related product manuals