POST error messages
POST is a program run at startup that initializes and runs some tests on installed hardware. An audible
and/or visual message occurs if the POST encounters a problem. POST checks the following items to
ensure that the workstation system is functioning properly:
●
Keyboard
●
Memory modules
●
Diskette drives
●
All SATA, IDE, and SAS mass storage devices
●
Processors
●
Controllers
NOTE If the Power-On Password is set, a key icon appears on the screen while POST is
running. You must enter the password before continuing.
Table 5-18 POST error messages
Screen Message Probable Cause Recommended Action
101–Option ROM Error. System ROM checksum. Verify the correct ROM:
1. Flash the ROM if needed.
2. If an expansion card was recently added, remove
it and see if the problem remains.
3. Clear CMOS. If the message disappears, there
might be a problem with the expansion card.
4. Replace the system board.
102–System Board Failure. DMA, timers. 1. Clear CMOS.
2. Remove expansion boards.
3. Replace the system board.
103–System Board Failure. DMA, timers. 1. Clear CMOS.
2. Remove expansion boards.
3. Replace the system board.
110–Out of Memory for Option
ROMs.
Option ROM for a device was unable
to run due to memory constraints.
Move the suspected card to a different slot to see if the
error resolves. Contact HP for assistance if necessary.
162–System Options Not Set. Your system configuration has
changed since your last boot, in which
case press F1. Or, a loss of power to
the Real Time clock has occurred.
1. Run Computer Setup (F10 Setup).
2. Set the date and time under Control Panel or in
F10 Setup, depending on the operating system.
3. If the problem persists, replace the RTC battery.
163–Time and Date Not Set. Invalid time or date in configuration
memory.
RTC (real-time clock) battery might
need to be replaced.
1. Set the date and time under Control Panel or in
F10 Setup, depending on the operating system.
2. If the problem persists, replace the RTC battery.
ENWW POST error messages 123
To Next Page
Loading...
Need help?
General
