5 | Product Overview INFICON
50 / 319 074-594-P1H Micro GC Fusion Operating Man-
ual
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for assistance
5.12.1.2 FCC RF Exposure Statement
WARNING
To satisfy RF exposure requirements, this device and its antenna must
operate with a separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other antenna or
transmitter.
5.12.2 Regulatory Compliance for CANADIAN Users
This section of the Operating Manual lists Industry Canada (IC) compliance
information for Micro GC Fusion.
This equipment contains an OEM Embedded Wireless Bridge (Ethernet to
Wireless LAN) Module
This device complies with RSS-210 of Industry Canada (IC) and is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
5.12.2.1 Industry (IC) Notices
This equipment complies with Canadian RSS-210.
CAUTION
This device has been designed to operate with an antenna having a maximum
gain of 5.0 dB. An antenna having a higher gain is strictly prohibited per
regulations of Industry Canada (IC). The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users, the antenna type and gain
should be so chosen that the equivalent isotropically radiated power (IEIRP) is not
more than required for successful communications.
To Next Page
Loading...
Need help?
General
