Connect a Device to a Management Console Using an RJ-45 Connector | 146
Connect an EX4100 and EX4100-F Switch to a Management Console Using the USB Type C Console
Port | 147
Connect a Device to a Network for Out-of-Band Management
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end. Figure 92 on page
145 shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 92: RJ-45 Connector on an Ethernet Cable
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
To connect a device to a network for out-of-band management (see Figure 93 on page 146):
1. Connect one end of the Ethernet cable to the management port on the device.
145
To Next Page
Loading...
Need help?
General