8. If you are returning accessories or eld-replaceable units (FRUs) with the switch, pack them as
instructed in "Pack EX4100 Switch Components for Shipping" on page 226.
9. Place the accessory box by the rear end of the chassis in the shipping carton.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Pack EX4100 Switch Components for Shipping
Ensure that you have the following parts and tools available:
• Anstac bag, one for each component—not provided
• An ESD grounding strap—not provided
To pack the switch components:
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not t together on one level in the shipping box.
• Place individual components in anstac bags.
• Use the original packing materials if they are available. If the original packing materials are not
available, ensure the component is adequately packed to prevent damage during transit. The packing
material you use must be able to support the weight of the component.
• Ensure that the components are adequately protected by wrapping them well with packing materials.
Pack the component in an oversized box (if the original box is not available) with extra packing
material around the unit so that the component is prevented from moving around inside the box.
• Securely tape the box closed.
• Write the RMA number on the exterior of the box to ensure proper tracking.
226
To Next Page
Loading...
Need help?
General