Juniper EX4100 User Manual

Pack an EX4100 and EX4100-F Switch for Shipping
Before you pack the switch:
1. On the console or other management device connected to the switch, enter the CLI operaonal
mode and issue the following command to shut down the switch soware:
user@switch> request system halt
Wait unl a message appears on the console conrming that the operang system has halted.
2. Disconnect power from the switch.
3. Remove the cables that connect the switch to external devices.
4. Remove all opcal transceivers installed in the switch (see Remove a Transceiver).
If you need to transport the switch to another locaon or return the switch to Juniper Networks, you
need to pack the switch securely in its original packaging to prevent damage during shipping.
Ensure that you have the following parts and tools:
• Number 2 Phillips (+) screwdriver—not provided
• The original switch packing material (cardboard box, accessory box and its contents, and foam
padding)
• An ESD grounding strap—not provided
• Anstac bag—not provided
CAUTION: Do not pack the switch in anything except its original container, or the
switch might be damaged in transit.
To pack the switch:
1. If the switch is installed in a rack or cabinet, have one person support the weight of the switch
while another person unscrews and removes the mounng screws.
2. Remove the switch from the rack or cabinet and place the switch on a at, stable surface.
3. Use the screwdriver to remove the rack mounng brackets from the switch chassis.
4. Place the switch in an anstac bag.
5. Place the boom poron of the packaging foam in the shipping carton.
6. Place the switch inside the cavity in the boom packaging foam.
7. Place the top poron of the packaging foam on top of the switch.
225

Juniper EX4100 Specifications

General

Brand	Juniper
Model	EX4100
Category	Switch
Language	English