PRECAUTIONS FOR BLIND SPOTS CAUSED BY CAB AND ROPS STRUC-
TURES
WARNING
The cab stays create blind spots.
When
operating, check carefully that there is no person or
obstacle in the surrounding area.
RECOMMENDED APPLICATIONS
In
addition to the following, it is possible to further increase the range of applications by using various attach-
ments.
DOZING WORK
Cut soil and sand and move them forward. When cutting a
slope surface, it is more efficient to always cut from top toward
bottom.
Do not apply excessive load which causes shoes continuously
slip.
Do not perform steering operation when heavy load is applied.
LEVELING WORK
NOTICE
Avoid leveling work on rocky or stony ground. It can damage the blade.
To finish the ground to a flat surface after digging or piling soil,
put a full load of soil on the front face of the blade and operate
the blade up and down in small movements while traveling for-
ward.
When leveling track shoe traces or small windrows, set the
blade at “FLOAT” and drive the machine at low speed in re-
verse while pulling the blade on the ground surface.
At this time, hold the lever with your hand for at least 1 second
so that the lever is held in “FLOAT” state securely.
Avoid running over stones or rocks to protect the blade.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-194
To Next Page
Loading...
Need help?
General
