1.
Remove the cover (A) on the R.H. fender
.
(B): Transmission oil filter
(C): Torque converter oil filter
2.
Remove the bolts (1) of transmission oil filter (B) and tor-
que converter oil filter (C).
3.
Pull up the cover (2) and remove the element (3).
4.
Clean the inside of the case and the removed parts, then
install the new element.
Replace the O-ring at the same time.
5.
Install the cover (A) on the R.H. fender.
METHOD
FOR CHECKING AND REPLACING ALTERNATOR AND AIR CONDI-
TIONER COMPRESSOR DRIVE BELT
METHOD FOR CHECKING ALTERNATOR AND AIR CONDITIONER COMPRES-
SOR DRIVE BELT
If the alternator drive belt is in any of the following conditions, the belt must be replaced.
MAINTENANCE MAINTENANCE PROCEDURE
4-55
To Next Page
Loading...
Need help?
General
