METHOD FOR STORING LADDER BY OPERATING FROM MACHINE
Push
the ladder up switch (5) on the switch box (1) at the side
of cab until the ladder stops automatically and the alarm stops
sounding.
METHOD FOR LOWERING LADDER BY OPERATING FROM MACHINE
Push the ladder down switch (3) on the switch box (1) at the
side of cab until the ladder stops automatically and the alarm
stops sounding.
METHOD FOR STORING LADDER BY OPERATING FROM GROUND
Push up the ladder operation switch (4) on the switch box at
rear of R.H. fender until the ladder stops automatically and the
alarm stops sounding.
NOTICE
If the operator is on the machine, do not approach the ma-
chine to operate the ladder.
ACTIONS IF MACHINE DOES NOT MOVE BY FAILURE
WARNING
Even if the hydraulic type ladder is in the activation position, the machine can travel by performing the
following
procedure. Use this method for moving the machine temporarily to a safe place. After moving
the machine to a safe place, immediately ask your Komatsu distributor for repair.
1.
Check that the parking brake lever is in LOCK position (L).
If
parking brake lever is not set to LOCK position (L), the
engine cannot be started.
HANDLE HYDRAULIC TYPE LADDER ATTACHMENTS AND OPTIONS
6-20
To Next Page
Loading...
Need help?
General
