METHOD FOR REPLACING DOOR DAMPER
Measure groove depth (A) of door damper rubber (1).
When groove depth (A) decreases to 2 mm or
less, replace the
damper.
The damper is installed at top and bottom, 2 pieces each on
the R.H. and L.H. doors.
METHOD FOR LUBRICATING DOOR HINGE
1.
If the door creaks when it opens or closes, spray lubricant
through the bushing slit of the hinge.
2.
If the bushing is worn, replace the hinge.
METHOD FOR CHECKING DOOR LA
TCH
WARNING
It is dangerous if the machine moves by mistake during in-
spection.
Stop
the engine and securely set the parking brake lever to
LOCK position (L).
1.
With the door open, check if the grease in the latch dried
out.
2.
If the grease is insufficient or dried out, apply new grease
to inside of the latch through portion (1).
REMARK
If the grease in the latch is dried out, the latch does not
move normally because of dust in it, and the operating ef-
fort of the handle may become heavy when you open the
door.
METHOD FOR CHECKING DOOR LOCK STRIKER
MAINTENANCE PROCEDURE MAINTENANCE
4-36
To Next Page
Loading...
Need help?
General
