GENERAL
BX1870,BX2370,BX2670,LA203A,LA243A,RCK48(P),RCK54(P),RCK60B,RCK60D,RCK54D, WSM
G-32
(6) Check Points of Every 400 Hours
Cleaning Transmission Oil Strainer
1. When changing the transmission fluid, disassemble and rinse
the strainer with nonflammable solvent to completely clean off
fillings.
2. When reassembling, be careful not to damage the parts.
• Since the fine fillings in the oil can damage the precision
component parts of the hydraulic system, the end of the
suction line is provided with an oil strainer.
9Y1210855GEG0019US0
Changing Transmission Fluid
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug at the bottom of the
transmission case and drain the oil completely into the oil pan.
2. After draining reinstall the drain plug.
3. Clean the transmission strainer.
4. Fill with new KUBOTA SUPER UDT fluid up to the upper notch
on the dipstick.
5. After running the engine for a few minutes, stop it and check the
oil level again, add oil to prescribed level.
6. Properly dispose of used oil.
• Do not operate the tractor immediately after changing the
transmission fluid.
• Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
9Y1210855GEG0038US0
(1) Strainer (2) Filter Plate
Transmission fluid Capacity
11.6 L
3.1 U.S.gals
2.6 Imp.gals
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
(A) Oil level is acceptable within this
range.
To Next Page
Loading...
Need help?
General
