Wiring the standard device
Basic devices in the power range 45 ... 55 kW
Motor connection
5
5.6
5.6.4
5.6-5
EDSVF9333V EN 3.0-06/2005
5.6.4 Motor connection
Note!
ƒ Fusing the motor cable is not required.
ƒ The drive controller features 2 connections for motor
temperature monitoring:
– Terminals T1, T2 for connecting a PTC thermistor or thermal
contact (NC contact).
– Pins X8/5 and X8/8 of the incremental encoder input (X8) for
connecting a KTY thermal sensor.
Wire T1, T2 only if t he motor is equipped with a PTC thermistor or thermal
contact (NC contact).
ƒ An ”open” cable acts like an antenna and can cause faults at the drive
controller.
Danger!
ƒ All control terminals are only base-insulated (single isolating
distance) after connecting a PTC thermistor or a thermal
contact.
ƒ Protection against accidental contact in case of a defective
isolating distance is only guaranteed through external
measures, e.g. double insulation.
PE
U
VW
T1 T2
+UG -UG
PES
PES
PE
M
3~
J>
PES
PES
PES
2.7 k
MONIT-OH8
15 V
3.3 k
7.4 k
9300vec139
Fig. 5.6-3 Circuit diagram of motor connection with PTC thermistor or thermal contact (NC
contact) at T1, T2
Motor with PTC thermistor or
thermal contact (NC contact)
To Next Page
Loading...
Need help?
General
