Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Transfering parameters to other controllers
7
7.2
7.2.6
7.2-9
EDSVF9333V EN 3.0-06/2005
Step Key
sequence
Action
1. Connect the keypad to the
basic device 2
2. Inhibit c ontroller: TerminalX5/28=LOW
The status display ”IMP” is lit.
The drive coasts
3. Pull the plugs X5 and X6 All control terminals have the defined state
”LOW”.
4. Select C0002 in the menu
”Load/Store”
Select code C0002 ”PAR LOAD” in the menu
”Load/Store” using the arrow keys.
5. Change to the parameter level The active parameter set is displayed, e.g.
display ”0” and ”Load Default”
6.
Select the correct copy
function
The settings stored in the basic device are
overwritten.
z Copy all available parameter sets into the
basic device and save them permanently.
The parameters are not yet active after
copying. Select the parameter set and load
it into the main memory. 7.2-7
Set ”20” ”ext -> EEPROM”
z Copy single parameter sets to the main
memory.
Copy parameter set 1:
Set Ö ”11” ”Load ext PS1”
Copy parameter set 2:
Set Ö ”12” ”Load ext PS2”
Copy parameter set 3:
Set Ö ”13” ”Load ext PS3”
Copy parameter set 4:
Set Ö ”14” ”Load ext PS4”
7. Start copying The status display ”RDY” goes off. ”BUSY”
is shown as parameter value.
If ”BUSY” goes off, the selected parameter
sets are copied into the basic drive. The
status display ”RDY” is lit.
8.
Change to the code level
A Display of the operating level
B Display C0002 and ”PAR LOAD”
9. If necessary, store separately
copied parameter sets
Select code C0003 ”PAR SAVE” in the menu
”Load/Store” using the arrow keys and
permanently store the contents of the
main memory.
10. Plug in plugs X5 and X6
11. Enable controller Terminal X5/28 = HIGH
The drive is running with the new settings.
Copying parameter set from
the keypad into the basic
device
To Next Page
Loading...
Need help?
General
