Safety instructions
General safety and application notes for Lenze controllers
2
2.1
2.1-1
EDSVF9333V EN 3.0-06/2005
2.1 General safety and application notes for Lenze controllers
(According to: Low-Voltage Directive 73/23/EEC)
Lenze controllers (frequency inverters, servo inverters, DC c ontrollers) and
the accessory components can include live and rotating parts - depending on
their type of protection - during operation. Surfaces can be hot.
Non-authorised removal of the required cover, inappropriate use, incorrect
installation or operation, create the risk of s evere injury to persons or
damage to material assets.
More information can be obtained from the documentation.
All operations concerning transport, installation, and commissioning as well
as maintenance must be carried out by qualified, skilled personnel (IEC
364/CENELEC HD 384 or DIN VDE 0100 and IEC report 664 or DIN VDE 0110
and national regulations for the prevention of accidents must be observed).
According to this basic safety information qualified, skilled personnel are
persons who are familiar with the assembly, installation, commissioning,
and operation of the product and who have the qualifications necessary for
their occupation.
Drive controllers are components which are designed for installation in
electrical systems or machinery. They are not to be used as domestic
appliances, but only for industrial purposes according to EN 61000-3-2.
When installing the controllers into machines, commissioning (i.e. starting
of operation as directed) is prohibited until it is proven that the machine
corresponds to the regulations of the EC Directive 98/37/EC (Machinery
Directive); EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when
there is compliance with the EMC Directive (89/336/EEC).
The controllers meet the requirements of the Low-Voltage Directive
73/23/EEC. The harmonised standard EN 61800-5-1 applies to the
controllers.
The technical data as well as the connectionconditions can be obtained from
the nameplate and the documentation. They must be strictly observed.
Warning: The controllers are products which can be installed in drive
systems of category C2 according to EN 61800-3. These products can cause
radio interference in residential areas. In this case, special measures can be
necessary.
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to EN 50178.
General
Application as directed
Transport, storage
To Next Page
Loading...
Need help?
General
