December 6, 2004 68P81083C20-D
3-4 Test Equipment, Service Aids and Tools: Field Programming
Mid Power Chassis
1. Place radio on bench with fins facing downward and away.
2. Remove the plastic cover. This position leaves the top side of the PC boards fully exposed
and the 18 pin connector (see Table 3-4) facing the operator. Note that the 18 pin connector is
offset left of center.
3. Place the control head directly in front of the chassis with the control head and chassis sides
aligned to each other. The two 18 pin connectors MUST also be aligned. This means that the
control head is sitting upright.
4. With the colored side of the control head extender cable facing upward all the way between
the control head and the chassis connect the cable to both control head and chassis 18 pin
connectors.
High Power Chassis
1. Place radio on bench with fins facing downward and away.
2. Remove the polycarbonate cover. This position leaves the top side of the PC boards fully
exposed and the 18 pin connector (see Table 3-4) facing the operator. Note that the 18 pin
connector is offset right of center.
R-1070A
(superseded by
R1319A)
Shields and surface-mounted component -
IC removal/rework station
Removal of surface-mounted integrated circuits
R1319A 110VAC
R1321A 220VAC
(supersedes R1070A)
6680332E82
6680332E83
6680332E84
Surface-Mounted Device Rework Station
R1319A/R1321A Reflow Nozzle
R1319A/R1321A Reflow Nozzle
R1319A/R1321A Reflow Nozzle
Removal of surface-mounted integrated circuits
For IC removal (approximate size 0.8 in. x 0.8 in.)
For IC removal (approximate size 0.6 in. x 0.6 in.)
For IC removal (approximate size 0.5 in. x 0.5 in.)
6685629A01 End Cutter Extraction tool for removable control head but-
tons.
HLN6621 Plug, coaxial Mini UHF male connector.
Note: this connector is delivered with the
radio. Prior to installation, replace the RF
connector provided with the antenna with
this connector.
Recommended RF connector to interface with
MCS 2000 radios. For use during bench test and
tuning.
Failure to follow these instructions may cause severe damage
to the control head.
If the cable is plugged in upside down the control head will
burn out.
Table 3-3. Recommended Service Tools
Part Number Description Application
!
a u t i o
!
a u t i o
To Next Page
Loading...
Need help?
General