68P81083C20-D December 6, 2004
Disassembly & Reassembly and Replacement Procedures: Disassembly to Transceiver Board Level
Remove the RF Shield
1. Pull straight up on the RF shield using the supplied handle.
Figure 5-12. Removing the RF Shield
Remove the PA Shield
1. Pull straight up on the PA shield using the supplied handle.
Figure 5-13. Removing the PA Shield
Remove the PA Board
1. Unscrew the 6 recessed, PA device screws using a T-8 Torx driver. Unscrew the remaining
screws (9 for VHF, 11 for UHF) using a T-10 Torx driver.
2. Remove the power and antenna connector retaining clips by inserting a small flat-blade
screwdriver between the clip and the underlying cavity wall and by gently prying the clip
upwards.
3. Gently disconnect the 2 and 12 position connectors from the RF board by rotating the PA
Board toward the chassis fins.
RF Shield
Handle
RF Shield
Handle
PA Shield
Handle
PA Shield
Handle
To Next Page
Loading...
Need help?
General